Prime. Dark colors, stains (once sealed), and previously unpainted surfaces (drywall, spackle, etc.) will need a primer coat, usually white. NOTE: most paint stores & home improvement centers will now tint primer (at no charge) to match fairly close to the color of the finished coat, that way two coats of primer need not be applied. Although not all surfaces need a prime coat, skip this step at your peril! Dark colors will likely show through the first -- or even the first couple-- topcoats of paint. Sealants and unpainted surfaces like spackle patches will absorb or repel moisture in a topcoat at a different level than the areas surrounding them. Applying a good primer coat will help even out these differences. Primer equalizes a wall to a uniform surface. It's like erasing a canvas before drawing a new picture. Although some will argue the point, you generally don't need to spend a great deal on primer or buy special primer. A cheap, 5 gallon (18.9 L) bucket of plain, flat white paint will usually do the trick and cover a large area. Give your primer at least 24 hours to dry (follow its instructions) before applying a topcoat. Denver House Painting
Flat, or matte finish on the no-shine end of the finish spectrum. A friend to walls that have something to hide, flat or matte paint (the terms are interchangeable) soaks up — rather than reflects — light, has the most pigment, and provides the most coverage. It's good for adults' bedrooms and other interior rooms that won't be roughed up by kids. That's because it's tough to clean without taking paint off.
Use a roller to paint the rest of the wall. A good method to use is the 'W method'. You start by painting a large 3 foot (0.91 m) square W on the wall. Then, without lifting the roller, you fill in the W. You can paint a wall section-by-section, and do the walls one at a time for best results. It's generally a good idea to use an extension pole for your roller instead of standing on a ladder. Make sure that neither the extension pole nor the roller has plastic handles, as plastic handles are flexible and this makes it difficult to control the painting.
Determine the coverage area for each color and estimate the number of gallons you'll need for each. For odd walls with angled ceilings, make your best guess. If you're not comfortable doing this, measure the wall at its highest height and multiply that by its width. Now subtract the lowest height from the highest height, multiply that number by the width, cut that answer in half, and finally subtract that new number from the original height by width. That should give you the wall area. House Painting Denver Colorado